« Reply #304 on: April 09, 2012, 07:21:50 PM »
I would lower the bottom bar more like this and maybe alter the angle of the vertical bar just a bit. The vertical bar wouldn't need the bend altered just a slit rotation and notch to line up the bottom. My paint shop skills are a bit limited.
Well, they already lowered the lower bar so it would meet at one point. GordonM just grabbed the pre-fixed version for his photo editing (impressive photo editing at that). The angle of the vertical bar was actually OK as it was sitting, I think your suggestion for tilting it a bit more is even better, but they do have to work with where the mount points are located.
I didn't realize just how much more I like the GordonM version until after I went back and looked at the other design a while, then looked back at the new slanted version. The more I look at the slanted ones, the better it looks. I hope it is not too late for this to be seriously considered...
Logged
Shoodaben (was Guhl) Mountain Runner ECU flash, Canyon Cages front/rear, Helibars risers, Phil's wedges, Grip Puppies, Sargent World seat-low & heated & pod, Muzzy lowering links, Soupy's stand, Nautilus air horn, Admore lightbar, Ronnie's highway pegs, front running lights, all LED, helmet locks, RAM Xgrip, Sena SMH10, Throttle Tamer, MRA X-Creen, BearingUp Shifter, PR4-GT, Scorpion EXO-T1200,etc