I got a set during this sale for my DR650 (I'm happy with the Denalis on my C14, so far), they arrived quickly
from China (not India) via express mail. I tested them and they are bright and work well but they are pole sensitive
(some LED lights have an internal bridge rectifier so you can hook them up backwards and they still work, these do not).
I also ordered the dimmer which has yet to arrive, I emailed them and they said it shipped separately.
I've got doubts, but I'll post here if it shows up and works.
edit 9-1-12: The dimmer showed up 8-31-12, shipped from India. It works*, comes with a remote fob which is good because there are no controls on the unit itself. The unit has memory that seems to survive during the power shut off. When the power is restored there is a full bright flash followed by the condition that was present when power was removed, be it dimmed, off, or full bright. The fob was tested at 10 feet and worked well. Most of the testing was done with only one light and the dimmer worked well. When the second unit was added in parallel it worked for a short while then quit*. I measured each LED unit at 2.7 amps so it should have been a total of 5.4 Amps that this 8 amp rated dimmer couldn't handle.(
Note: this testing was done with 12v battery power only, the bike was not started) I opened it up and found that a wire near the output transistor had un-soldered itself. I re-soldered the wire and hooked it back up and the LED lights came on at full bright and the unit wouldn't respond to the fob. In short order I could see that the output transistor was getting hot and the solder near it was molten again so I shut it down. The lights are fricking bright and I hope they'll hold up under rough road/trail conditions , but I
can't recommend the $14.50 dimmer. (since ordering, I've seen the same dimmer priced from $6.43 to $49.00)