« Reply #26 on: January 18, 2012, 12:14:12 PM »
I am looking at the part identified as Arm-Suspension,Uni Trak, #39007. I see that it uses two bearings in the center hole. My question is does this have a boss inside that the bearings mate against? Also, what would be the best way to remove the bearings?
It's been a while since I had mine apart but I don't recall anything in the bottom hole of the linkage along the lines of a boss or spacer or anything between the two sets of bearings. As far as best way to remove the bearringa.....my low-tech garage called for the use of a socket just the right size to fit inside the hole and then use of a hammer to drive both bearings out. Installation was just the reverse since I was moving my bearings from the stock linkage to a lowering link rather than replacing the bearings with bushing.
Logged
02 Conc- Corbin seat, Cee Baileys shield, MCL fork brace, 4 pot calipers w/zrxmopar's adapters, 310mm rotors, SS brake lines, 1.1 Sonic springs, C14 rear shock, TCro's stick coils, SiSF's economy jet kit, front tip-over bars w/hwy pegs, KB bar risers, fender extender, block off plates, HVMP bar end weights, grip heaters, Murphs fuse block, 55W HID upgrade, relo'd coolant bottle & helmet locks