I think I have a similar problem. Could you please advise exactly what you tightened and the torque specs. you used.. A pic would be appreciated . (On the old forum there was a sticky with a lot of torque specs. but couldn't find it on the new one )
Many thanks
Here is the torque specs in the C-14 area.
http://www.zggtr.org/index.php?topic=1652.0Here is what the manual says:
○Tighten the steering stem nut with 55 N·m (5.6 kgf·m, 41
ft·lb) of torque first, and loosen it a fraction of a turn until
it turns lightly. Afterward tighten it again with specified
torque using a steering stem nut wrench [A].
Special Tool - Steering Stem Nut Wrench: 57001-1100
Torque - Steering Stem Nut: 23 N·m (2.3 kgf·m, 17 ft·lb