Awww, you should have let me know you were in CO, we could of met up and had a beer!!
Me too! Demand has risen so I am in the middle of a second batch of handmade ones, about 3/4" taller to work better with risers. I have to get this batch done and a 'perfect' sample so that the fabricator can duplicate them otherwise, I run the risk of having them mis-cut/bent.
Hope to have ~35 pair available By Nov 1st.
So your making "thicker" ones now than what you currently have?
I too would be interested in a set for my '08. There must be SOMEBODY in the Denver area you can buy a cold bevie and get some measurements from .
You would think but no takers as of yet
What measurements do you need? Yes, I have a caliper and mic and I'm not afraid to use them! LOL
Hey Flathead,
I'm interested in a set for my 2011 when ready. You said this new batch is a bit higher to accommodate risers?
I just ordered a set from Flathead for my '11.
Me 2... I think I helped Flathead delve into new territory
It looks like u r near Colorado Springs? About 1400 mile RT - temptingActually closer to Denver, 80° today and tomorrow!! Come on doen
I should mention that Flathead sent me a pair for my 2011. Installed them in, oh I dunno.....seven minutes. It's a very simple design, and they work very well, even with my 1-1/2" risers.
Small issue: the top spacer for one of them was a little shorter than the other, but enough so that the CB Ultra windshield rubs up against the deflector at the lowest position on that side. I need to get another spacer to get the deflector a little further back.