Your wafer looks to have corrosion.yeah - thinking about soldering on a wire or two at the joints for now until I can find a new board, I guess.
It's usually a futile endeavor. It is better to buy a new/good used jbox at this point.
But since you have come this far you can try your thing.
wow. you work fast. good luck.
so, reflowing a couple junctions got ya going... I sureley hope you took the time to actually reflow and add solder to all of those relay solder points. or, maybe you will see them again, after asking why something else is not working...No - bad posting on my part. I re-flowed ALL the solder joints (well... all but like 3 of the fuses that were perfectly clean and fine), but went and ALSO ran two wires where corrosion of the board looked very bad. But as I said, this one is going to become a back up to the one I just bought from another forum member today. Can't see the point running this box for very long with all that corrosion on it.