Author Topic: Corbin heated seat question  (Read 9366 times)

Offline maxtog

  • Elite Member
  • ******
  • Posts: 8948
  • Country: us
  • 2011 Silver
Re: Corbin heated seat question
« Reply #20 on: December 09, 2011, 09:17:51 PM »
I'm thinking I'm gonna be all over this one!! Just hope I can figure out the wiring mods to adapt this to the Corbin seat.

You don't need any "mods", it is just inline of the power to the seat and/or clothing.  Done.
Shoodaben (was Guhl) Mountain Runner ECU flash, Canyon Cages front/rear, Helibars risers, Phil's wedges, Grip Puppies, Sargent World seat-low & heated & pod, Muzzy lowering links, Soupy's stand, Nautilus air horn, Admore lightbar, Ronnie's highway pegs, front running lights, all LED, helmet locks, RAM Xgrip, Sena SMH10, Throttle Tamer, MRA X-Creen, BearingUp Shifter, PR4-GT, Scorpion EXO-T1200,etc

Offline ljcorby

  • Full Member
  • ***
  • Posts: 439
  • Country: us
  • COG#: 9359
Re: Corbin heated seat question
« Reply #21 on: December 10, 2011, 06:12:27 AM »
I am definitely going to pull the trigger as well as soon as they are available.  Like i said in an earlier post, I spoke to Sargent and they are a little behind. They informed me they would be available mid Jan 2012.....crossing my fingers.....
10 Kawi Concours 14 ABS

Offline jimmymac

  • Arena
  • Full Member
  • ***
  • Posts: 1076
  • Country: us
Re: Corbin heated seat question
« Reply #22 on: December 10, 2011, 07:59:40 AM »
I just wired in a relay on mine. I connected to the fused accy wires to power the circut.
Connected straight to the battery on the other side.
Besides forgetting, and leaving it on, the guys at work like to switch it on when it's hot outside. ::)
The grass isn't always greener.