Hey everyone,
I recently got a set of ZX14 throttle bodies to put on my bike from ebay. Well they arrived without injectors, sensors etc so I swapped them over to the ZX14 throttle bodies and installed them. I started to button it back together and before I put all the fairings back on I went to try to start it and It runs fine, but I'm getting FI codes 11 and 32, and the subthrottle actuator (flies) makes a ticking sound on powering on. Code 11 is the main throttle sensor and 32 is the subthrottle sensor. So I figured well maybe I swapped the sensors around when I was putting them on.. Nope it actually changed the fault from 32 to 62, and I confirmed the sensors were originally in the correct places. I pulled the throttle bodies back off to check that everything was connected correctly and looked good and I did not see anything wrong. Well to see if there was anything wrong with the TB I tried swapping everything BACK over to the C14 bodies and I still get the same fault and the actuator still clicks (both bodies have the actuators installed so it isn't the same one).
Well call me an idiot but am I missing anything obvious? I tried installing the sensors in the same positions on both bodies and then messed with the adjustment but to no avail. Anyone else have issues when they installed theirs?