« previous next »
  Go Down

Author Topic: Anyone installed a BMC Race Filter in C-14 yet for the street....??  (Read 2575 times)

Offline ninjawarrior1400

  • Full Member
  • ***
  • Posts: 351
  • Country: us
  • "There is no second place winner in a gunfight."
Anyone installed a BMC Race Filter in C-14 yet for the street....??
« on: October 12, 2012, 07:17:35 AM »
Have a new BMC Race Filter, delayed installing because of time to remove plastic to get it in...but it says it is for race applications only...so wondering how it will filter out all the road dirt that the stock unit does.

I have 3000 miles on my new ZX14r and slammed it down a few times on concrete and the dirt and bugs that came out of it was very scary!  So, wondering if I install the BMC if it will require cleaning every few months or if it will allow the sand and road dirt to get into the engine...

Ideas and opinions please.....

NW
Logged
Ninjawarrior

Offline Spanky

  • Full Member
  • ***
  • Posts: 283
  • Country: us
Re: Anyone installed a BMC Race Filter in C-14 yet for the street....??
« Reply #1 on: October 12, 2012, 11:08:59 AM »
I don't know if it is the race filter. I have the BMC that came with the area p full system and it seems to work fine. It is easy to clean. I don't know how it compares to the stock filter in terms of how much material gets past the filter. I have about 45K on the bike so far and no problems.
Logged

Offline jamiemac

  • Full Member
  • ***
  • Posts: 605
  • Country: us
Re: Anyone installed a BMC Race Filter in C-14 yet for the street....??
« Reply #2 on: October 12, 2012, 02:58:42 PM »
I have one. Works fine. Haven't cleaned mine yet with about 12,000 miles on the filter. Probably time.
Logged
2008 C14, Area-P carbon fiber, PCV, Rostra Cruise, LAAM leather seat, Optilux 1500 & MondoMoto MM10 lights, Cee Bailey windshield, BMC air filter, Warm & Safe dual dash mounted heat troller.

Offline robbie

  • Jr. Member
  • **
  • Posts: 31
  • Country: us
  • Tampabay, FL
Re: Anyone installed a BMC Race Filter in C-14 yet for the street....??
« Reply #3 on: October 12, 2012, 04:34:38 PM »
I got one with my area p kit from fuel moto. No problems with it.
Logged
2009 Kawasaki Concours 14, 2003 Goldwing, 2002 Goldwing, 2015 F-150, 2018 JK Wrangler, 2002 TJ Wrangler

devilboy

  • Guest
Re: Anyone installed a BMC Race Filter in C-14 yet for the street....??
« Reply #4 on: October 12, 2012, 06:00:52 PM »
Quote from: ninjawarrior1400 on October 12, 2012, 07:17:35 AM
Have a new BMC Race Filter, delayed installing because of time to remove plastic to get it in...but it says it is for race applications only...so wondering how it will filter out all the road dirt that the stock unit does.

I have 3000 miles on my new ZX14r and slammed it down a few times on concrete and the dirt and bugs that came out of it was very scary!  So, wondering if I install the BMC if it will require cleaning every few months or if it will allow the sand and road dirt to get into the engine...

Ideas and opinions please.....

NW
I put on a K&N reusable filter the other day. you dont have to remove all the tupperware to get at the air filter slot  just remove certain key screws(bolts) and disconnect one wire loom harness . whole thing  R&R   25 minutes...K&N is supposed to be checked , cleaned, and re-oiled every 10K miles..  key things are to allow it to fully dry after cleaning air filter and oiling with a nice light even coat of the oil..not familiar with BMC but I suppose it is along the same lines...
Logged

Offline ZG

  • Arena
  • Hero Member
  • *****
  • Posts: 6677
  • Country: us
Re: Anyone installed a BMC Race Filter in C-14 yet for the street....??
« Reply #5 on: October 12, 2012, 08:26:41 PM »
Quote from: devilboy on October 12, 2012, 06:00:52 PM
I put on a K&N reusable filter the other day. you dont have to remove all the tupperware to get at the air filter slot  just remove certain key screws(bolts) and disconnect one wire loom harness . whole thing  R&R   25 minutes...K&N is supposed to be checked , cleaned, and re-oiled every 10K miles..  key things are to allow it to fully dry after cleaning air filter and oiling with a nice light even coat of the oil..not familiar with BMC but I suppose it is along the same lines...

+1 on K&N...  :thumbs:
Logged

Offline curly

  • Full Member
  • ***
  • Posts: 185
  • Country: us
Re: Anyone installed a BMC Race Filter in C-14 yet for the street....??
« Reply #6 on: October 14, 2012, 03:54:22 PM »
I run the BMC also. Have not put enough miles on it to require cleaning yet but amonsgt the racer boys and fuel-moto it's the way to go.
Logged
Confidence is the feeling you have before you realize the full measure of the situation.

'09 in Black.

Offline wildnphx

  • Arena
  • Full Member
  • ***
  • Posts: 432
Re: Anyone installed a BMC Race Filter in C-14 yet for the street....??
« Reply #7 on: October 14, 2012, 04:44:06 PM »
Quote from: curly on October 14, 2012, 03:54:22 PM
I run the BMC also. Have not put enough miles on it to require cleaning yet but amonsgt the racer boys and fuel-moto it's the way to go.

I also run the BMC and have about 30k miles on it... no issues to report, just clean when you are suppose to.
Logged
  Go Up
« previous next »