How did you splice them in to the bike wiring? And were there any unintended consequences?
I had my covers (Tupperware) all off because I was doing the running/light LED install. So I tapped
into the signal connectors on each side just at the connector above the signals themselves. If I was
just going to do the signal mirrors and not remove anything but the top covers then I would go
under the rubber boot on the left front side and tap in there. Both signals are available there so you
would need to run a wire across to the right side under the center top tank cover/'08-'09 glovebox for the
right mirror signal. The schematic for the connector in the left front boot is here:
(Disregard the orangy-red dots with the yellow centers, that had to do with my other post.) You'll need to
connect to the green wire for the left mirror signal and the gray wire for the right mirror signal.
As for unintended consequences, I haven't found any, yet.