« previous next »
  Go Down

Author Topic: Murph Tip over bar info ++ more  (Read 950 times)

Offline sgilbert14

  • Full Member
  • ***
  • Posts: 253
Murph Tip over bar info ++ more
« on: April 29, 2013, 02:36:25 PM »
I picked up a set of Tip Over bars this winter. I am looking for the directions to mount the fronts and what the spacer I  missing. I have 3 that came with it 15, 35' and 20 cm and have no clue as what the last one should be. Backs went on no problem but the front????

Also, pulled my rear shock to change the fluid and my cup was knocked so now I cannot measure out the right amount. Any have the volume needed to fill it back up? What is the best stuff to use? Thanks !
Logged

Offline Outback_Jon

  • Arena
  • Full Member
  • ***
  • Posts: 427
  • Country: us
Re: Murph Tip over bar info ++ more
« Reply #1 on: April 29, 2013, 04:53:59 PM »
It just so happens that I have a Tip-Over Bar service kit that I am about to install.  (After bending one of the bars last fall autumn.) 
Logged
"Outback Jon" Gould *** South Cairo, NY *** COG #9506 *** 2006 C10 "Blueline" *** CDA #0157

Offline sgilbert14

  • Full Member
  • ***
  • Posts: 253
Re: Murph Tip over bar info ++ more
« Reply #2 on: April 30, 2013, 09:09:58 PM »
Thanks a ton. I now know that I am missing one of the 5/8" spacers and I could use a piece a SS pipe to make that.
Logged
  Go Up
« previous next »