when this thread was so graciously begun by Lord Frederick III.Hey "Fred", didja see that? "Gracious".
Here's the one I like:
I like the looks of that one the best. It seems the most OEM'ish of the bunch. Looking at these dimensions though:
Mounting hole: .48"
Bezel diameter: .55"
Button diameter: .35"
Length overall: 1.03"
Length of threads: .26"
Hex nut size: 9/16" or 14mm
I am not sure if I can find room in the factory housing. Anyone that has had it apart care to comment?
This monkey can even work a camera:
May need to bend the tabs to the side to clear the bar. I think it will fit. The hole will have to be carefully posistioned to seat the swiych bezel on the flat part and with clearance of the windshield switch which will put it straddleing the split I think.
Hey "Fred", didja see that? "Gracious".
By the way, why is yer location different in UK/US forums?
Perhaps I should change my name on here too.
Here is the switch I used, think it looks kind of OEM.I like it where you get it?
Here is the switch I used, think it looks kind of OEM.
http://www.gamainc.com/site/epage/128634_941.htm Just installed today.That's the perfect switch for this aplication, is a little big but the best thing is that is water proof, just ordered mine
Here is the switch I used, think it looks kind of OEM.
Here is the switch I used, think it looks kind of OEM.Is there any ground wire in any of the switches in that housing? did you run the wires inside where the all other wires goes from that housing?
Is there any ground wire in any of the switches in that housing? did you run the wires inside where the all other wires goes from that housing?ok let me answer that question myself the answer is YES, the black and yellow wire that goes to the horn switch is ground
Thanks
Here is the switch I used, think it looks kind of OEM.