Long time, no post. I've let my poor Connie sit for too long and I wanted to give it the proper treatment before getting back on the road. I figure it'll need a good carb cleaning and I figured now might be as good a time as any to finally get a Japanese Phillips screwdriver. Could anyone point me towards a good source for one? Preferably one that won't break the bank (or demand my unborns for shipping purposes)?
Bonus question, does anyone have a source for stainless steel socket cap screws to replace the OEM butter-screws?
If you plan on tossing the screws why bother with the JIS driver? I've never not been able to get stuck screws out with nothing more than a good fitting phillips and some PB-Blaster penetrating oil.
You can also buy the SS Carb Screws in kit form from our good friend Murph @ www.murphskits.com
I thought about skipping it and going with a regular #2, but I like to use new projects as excuses to get new tools. Even if it is only loosely validated.
All of the stock screws on the fairing are #3 Phillips, not #2. If you're "cammimg out" with a #2, try using a #3 and I think you'll be happy. (Much cheaper too than a JIS driver) Good, multi-tip models can be had cheaply at Harbor Freight stores. I carry a short 4.5" handle along with a 3" #3 tip under the seat with the stock tool kit. Haven't rounded out a single screw since I went to this setup. Mike in TX