« Reply #123 on: September 04, 2019, 03:34:49 PM »
fyi; When I installed my bearinged up shifter it would move in and out slightly {as the bearings were not tight in the shifter}. {I think this may be what caused the gap that Maxtog had}
Murph had me put Loc Tite on the OD of the bearings. (I think I used Surperglue Gel as that was what I had) That prevented that little movement of the bearings. Problem solved.
I was under the assumption that the movement meant that it wasn't tight enough. There certainly isn't any movement now. :/
Logged
Shoodaben (was Guhl) Mountain Runner ECU flash, Canyon Cages front/rear, Helibars risers, Phil's wedges, Grip Puppies, Sargent World seat-low & heated & pod, Muzzy lowering links, Soupy's stand, Nautilus air horn, Admore lightbar, Ronnie's highway pegs, front running lights, all LED, helmet locks, RAM Xgrip, Sena SMH10, Throttle Tamer, MRA X-Creen, BearingUp Shifter, PR4-GT, Scorpion EXO-T1200,etc