Great information T Cro, but it has nothing to do with the question. I'm running a bias ply Pirelli Rte 66 on the rear of my '01 and it works beautifully with the stock front tire. I have over 3K on it, mostly highway and mountain roads and it shows minimal wear right now. Mike in too hot TX
so if I did my research thoroughly, I find that only dunlop and avon make rear oem sized radial tires for the C10. is this correct? the sport radial oem dunlop; and the avon azaro....
Considering that I've seen that the OP wants to stick with Radial tires front/rear and is having significant issues with making up his mind on which tires to purchase I'm trying within my ability to point out that the 110/80 fits the 3.0" rim very well and will even improve the handling of the Concours thus I believe that my information is very valid.
While I don't have pictures to show you what you would like to see; I'll try to paint you a verbal yet slightly exaggerated picture. The K-Series 120/70-18 when mounted on the 3.0" rim tends to take on a rounded yet triangular shape with only a narrow rolling strip of rubber in contact with the ground. While this will give the bike a faster sport-bike like turn in as when you lean the bike over it rolls over that edge and the weight falls over. This will give you fast turn in but a heavier return as you have to muscle the bike back up and over that ledge. When you install a 120/70 from other manf on the 3.0" rim it will be even further pinched as the 120/70 is best suited when installed on a 3.5" or 3.75" rim and while this works OK at best the tire is not giving you the profile it was designed to give. On the other hand when a 110/80 is installed on the 3.0" wide rim it will take on a very natural broad/wide and rounded profile much akin to a riding a softball as compared to riding a hardball; this is because the 110/80 was made to fit on a narrower rim. But keep in mind that 3.0" is listed as an acceptable rim width whereas the 3.0" rim is not listed as an acceptable width for the 120/70 at all. These differences are really very easy to see when you look at bikes with "properly" fitted rims and tires such as the ZRX/ZZR etc with a 120/70 mounted on a 3.5" rim. This is why many skilled riders will swear by the 110/80 in place of the 120/70 as they have found that the bike will roll freely from one side of the tire to the other without that abrupt transition in the middle or falling sensation.
That is correct; they are the ONLY manf that I know of that currently produce a 150/80-16R for the rear of the bike.
awesome reply, lots of valuable info. there.
tbunder I hope you don't mind me dropping in.
I'm seriously considering a C10 but also seriously spooked by rear tire choices going away and no matched sets. So if Avon is the only radial rear what do you match it with up front? Are you at all concerned about the 16's going away?
Bunder sold his C10 and has not returned since the 19th .
I've just checked the Dunlop website and still see both the K700 and D205 Radial listed in the 150/80-16R sizing so I've no clue as to why they have become so hard to find; and while it means nothing Dunlop says that they are committed to these OEM sizings. For many so long as there is the AVON Radial Storm to be had for the rear they will look no further and I don't see AVON dropping that tire either. Even if the 150/80-16 radial tire were to go away there will always be large selection of this size in Bias ply as will there be in the next up sizing the 160/80 as these tire sizes are much too popular to abandon.
As to not finding matched sets it really matter very little as long as the types of tires complement each other you will be fine; my only comment is to never mount a touring or cold compound in the front with a sport compound in the rear.
Also expand your search to include the 110/80-18 (a better fit in my opinion than the stock 120/70) for the front as well as the 130/80-18 bias and again you will never lack for selections.
Listen to the true old time voices here not the newbies and they will tell you that with a good set of bias tires many many of you would never know the difference; and the same can be said for the mixing of radial front and bias rear it works too dam good to dismiss.
OR you switch out your rims for 17" front and rear and never will you lack for a selection of tires.
Many thanks T Cro. Yes, we newbies tend to get a bit worked up don't we? I found the 17" conversion threads which is reassuring as are the voices of reason. I'm sure there are threads debating the merits and effects of size choice within the the freedom of 17" selections but that can wait for another day. Today I need to bounce over to rick3foxes' "Getting ready to take the leap..." thread to see which of the local C10's he's looking at will be left.
Didn't know the D205 was still being made for the rear in the 16" size.