SOLD! REDUCED $ Early C-10 4 pot adaptors + calipers

[GeeBeav]

4-pot adaptors from Russell (enim57) with instructions, with Nissin calipers.
Fits early Concours 86-93(?), the ones with single-piston calipers.
Fits stock-size rotors.
Never installed, so unsure about caliper seals. Come with used pads.
Also s/s lines, came with calipers, look too short for a C-10 but not sure.
I have $200 in this, will sell for $120, shipping to US 48 included.

[GeeBeav]

Reduced to $100.

[GeeBeav]

Now on ebay. Item 261551868582.

[GeeBeav]

Thanks to Russell (enim57) for use of pic of installed calipers.

[RFH87_Connie]

I already have this this but for someone out there with an early model, this is a very good deal.

[connie_rider]

GeeBeav, you didn't mention which diameter rotors these work with?

I built a similar set up, that I use on my Connie. (03)
I built mine to work with the stock rotors, as I didn't want to change rotors too.
With the 4 Pot calipers the stopping power is better than stock.
If these work with 120 mm rotors, they would be even better.

Ride safe, Ted

[wahrsuul]

Would these calipers work on an newer model with different adapters and bigger discs?

[connie_rider]

Warsul, the Calipers would fit, but the adapters would not fit your Later Model C-10'.

You can buy Nissin or Tokico calipers on Ebay/etc in this design, but it's difficult to find them for $100, and difficult to know which calipers to buy.
So, this is not a bad deal for you.
BUT,,, it is a great deal for someone with an earlier C-10.

Ride safe, Ted

[GeeBeav]

GeeBeav, you didn't mention which diameter rotors these work with?

Stock size rotors, as stated in the OP.

Thanks for all the comments.