Good day,I think most obvious cause would be a bad/dirty switch and easiest to rule out. I don’t think the 2 Gen bikes have an auto-down feature. Did you recently wash the bike and possibly get some water in the switch housing? It isn’t too tough to take it apart and inspect.
I was ridding my 18 Conny yesterday when for no reason the windshield lowered itself. When I hit the switch to move it back up it would go but as soon as I released the switch it would lower itself again to the lowest position. I could sometimes stop the shield from lowering if I pushed the switch to raise the shield a few times.
I restarted the bike a couple times before the gremlin went away and didn't come back for the rest of the ride.
Any ideas on what may be causing this?
Thanks,
I think most obvious cause would be a bad/dirty switch and easiest to rule out.
I don’t think the 2 Gen bikes have an auto-down feature.