Has anyone done this? I installed My rostra about a year ago, & would like to wire it with a 3 position switch for set/accel, coast & do away with the switch on the bars.
I have virtually forgotten everything about My install. Hopefully this will take care of My issue of shutting down when I hit large bumps.
I just went from momentary contact switches (two switches) to the stock Rostra switch to eliminate the same problem. Not sure yet if that will work or not.Let Me know if Your problem goes away Brian. I'm using the Rostra 250-3592 switch with led indicators at the top. Mine switches off when i hit bumps & will not resume. I can reset it usually, just not resume the previously set speed. Weird.
Brian
Let Me know if Your problem goes away Brian. I'm using the Rostra 250-3592 switch with led indicators at the top. Mine switches off when i hit bumps & will not resume. I can reset it usually, just not resume the previously set speed. Weird.
If there is no ability to resume, then it indicates the unit lost power. Check both the power leads, especially the ground lead. Odds are there is some interruption in power to the Rostra (not the switch itself but the actuator).OK, That makes a lot of sense. Ya know, I retired from auto service about 12 years ago, & I can Tell Ya that diagnostic abilities are a perishable skill if You don't use it.
Brian