alot of folks are waiting for those that have done the mod to dyno their bikes.....a few "seat of pants" reviews but no hard data.........i'd also be curious about MPG changes at steady cruise modes.........maybe we should start a dyno fund
I went to the open house at my local dealer. They had free dyno runs. I waited in line for 1 1/2 hours in the rain. Finally my turn. Everything is hooked up and the dyno operator does a couple of pulls. He stops and starts fiddling with his computer. Re-boots it and starts again. Another pull and I'm getting excited. Still no cigar. After some more screwing around, he says it seems water has gotten into some electronics on the dyno somewhere so no HP numbers show. Damn. We did see however that my A/F ratio looked good. I need to know! Anyway I will be going to the dyno operators shop next week to finish this whole thing. I have an 09 with a full Yoshimura pipe, PCV, Autotune, K&N air filter and ZX14 tb's with flies removed. I will post my results.
^ Does that bike have ZX-14 throttle bodies installed? Because that's what this thread was pertaining to.
Does the ZX14 tb affect the traction control in 2011 C14's?
my buddy has a dyno about a block from my house.he bought it second hand,and the guy he bought it from is suppose to be down here today to show him how to tune with it.i'm waiting to install my zx14 tb untill after his "training". we did do a pull with my connie just for giggles,and it showed 157hp.WE KNOW NOTHING ABOUT THE SET UP OF THE DYNO,was just a pull to be doing a pull.
my bike is an '08 with full area P,k/n filter,flies removed,and a PC III with fuel moto map.as soon as he gets his training,we'll do another pull before the tb swap.then i will install the zx14 tb and tune.i'll let ya'll know what we come up with.
Just speculation here but I would say yes it would affect the KTRAC. It might be so small of a difference to be noticeable but KTRAC makes me want to stick with the 2009 and older bikes since the power has gotten so addictive after pulling the flies.
my buddy has a dyno about a block from my house.he bought it second hand,and the guy he bought it from is suppose to be down here today to show him how to tune with it.i'm waiting to install my zx14 tb untill after his "training". we did do a pull with my connie just for giggles,and it showed 157hp.WE KNOW NOTHING ABOUT THE SET UP OF THE DYNO,was just a pull to be doing a pull.
my bike is an '08 with full area P,k/n filter,flies removed,and a PC III with fuel moto map.as soon as he gets his training,we'll do another pull before the tb swap.then i will install the zx14 tb and tune.i'll let ya'll know what we come up with.
ZX-14 TBs going in later this week. WHOO HOO! SOTP Dyno report after first ride... and more after trims are accepted.You going to do a"before" dyno run also? The comparison would be cool.
Barry