« Reply #27 on: June 11, 2022, 06:07:58 AM »
I ordered the "PC-Auto Bond" as indicated, above [...] has a mixing tube that can only be used once,[...]it was not as thick as I had hoped/expected
Ah. Looking at their products pages, one can buy additional mixing nozzles with different capacities. Then it occurred to me.... perhaps you fill the tube and WAIT a short while before dispensing it, for it to thicken some? Of course, there are no instructions for using the tubes.
Anyway, it is a very, very solid bond now. A tiny bit squirted out around the edges and I could feel it is much harder (less flexible) than the OEM stuff. I hope it never has to be removed for any type of service, because it is probably impossible at this point. Hey, at least I will never lose the covers!
« Last Edit: June 11, 2022, 08:56:14 PM by maxtog »
Logged
Shoodaben (was Guhl) Mountain Runner ECU flash, Canyon Cages front/rear, Helibars risers, Phil's wedges, Grip Puppies, Sargent World seat-low & heated & pod, Muzzy lowering links, Soupy's stand, Nautilus air horn, Admore lightbar, Ronnie's highway pegs, front running lights, all LED, helmet locks, RAM Xgrip, Sena SMH10, Throttle Tamer, MRA X-Creen, BearingUp Shifter, PR4-GT, Scorpion EXO-T1200,etc