Hello All,
 
I just finished replacing the factory side reflectors with Murph's side marker/turn signal lights. I followed the wiring instructions found here on the forum earlier. The two sides are basically wired identically, still, the turn signals work in "alternate" mode with the factory front signals on the left hand side, while they work "normally" on the right hand side. What can be the problem?
Thank you in advance for any tips!
Las

Nothing wrong. Completely normal.

You have to wires on the alternate mode side backwards. If you have a multi meter or continuity indicator test the good side to figure out proper set up for other side.

Ride safe, Keep sharp.
Tj