I never got mine to enter diagnostic mode either. Never got the light to blink when turning the rear wheel. But it's been working great for the last 3 years anyway.
Sounds like you take it out, try it and keep your finger on the kill switch.
I never got mine to enter diagnostic mode either. Never got the light to blink when turning the rear wheel. But it's been working great for the last 3 years anyway.
Sounds like you take it out, try it and keep your finger on the kill switch.
I'm throwing this out there in hopes that SOMEONE has had the same issue or knows how to fix it. I am installing the Rostra CC and have everything mounted and finished wiring it up last night. I confirmed the relay on the brake works and the control pad lights and powers up (the orange LED comes on when I click the "on" button on the control pad).
I tried to enter "diagnostic mode" by following the instructions and holding the Resume/Accel button while I powered on the bike. Problem is, it's not entering diagnostics mode. I get no LED indicator when I pull the brake or push on any of the switches...I get nothin ! I know I didn't miss any connections and wired it up according to Brian's guide (great guide by the way) so I am at a loss . I don't really want to go back and check every connector (used posi-taps, Bullet Connectors, and Insulated Spade Disconnect Connectors instead of splicing).
Does this ring any bells? I know it's a long shot but I thought I would try.
Thanks!
According to Brian's guide (just below Fig 7)
The harness under my thumb is the VSS harness that comes with the bike. The harness above my fingers that the bullet connectors and wire feed into is the harness for the Rostra and just wrapped with electrical tape. You can also see the bottom of the Rostra throttle cable mount and throttle cable in this picture. The VSS itself is the rectangular unit visible on the top of the left side engine cover. It is retained with a single screw and is O-ringed so there is not gasket to replace.
3) Light green Rostra wire to Black / white dot on the motorcycle. Note: Do not attach this wire until after the diagnostic procedure is done. The Rostra will not enter diagnostic mode if the clutch wire is connected to the motorcycle. Make the clutch wire to the Rostra NSS the last connection after all diagnostics are completed but before test riding with the cruise control.
Glad to see you got it installed. Have a good test ride and may the force be with you.