Kawasaki Concours Forum

The C10, aka Kawasaki Concours - The Original => Accessories and Modifications - C10 => Topic started by: sroby on August 28, 2011, 02:34:16 PM

Title: Need Helibar c-10 Pic of throttle cable routing
Post by: sroby on August 28, 2011, 02:34:16 PM

I finally got around today to putting on my Helibars on my 06. Everything is good on the left side choke and clutch cable, harness and all.  Right side is good with the exception of the the throttle cables.  In the instructions they say route the t- cables down the backbone and to the right of the steering head.  I have done that but I am confused in the meaning of the back bone.  Do they mean just losely zip tie it to the back bone and it rest right underneath the tank? or go down the right side of the backbone underneath the frame tubes?    If anybody has any pics of the way yours is routed I would appreciate it.  Thx Steve

Title: Re: Need Helibar c-10 Pic of throttle cable routing
Post by: tvpierce on August 29, 2011, 06:15:28 PM

I don't have Helibars, but have bar risers.  I routed mine to the right of the spine.  They go between the right coil and coil mounting bracket on the frame.

Title: Re: Need Helibar c-10 Pic of throttle cable routing
Post by: elvin315 on August 29, 2011, 06:35:36 PM

You're welcomed to root through my albums. There are bound to be a few shoots that will help you.

http://www.pbase.com/elvin315/the_kawasaki_concours (http://www.pbase.com/elvin315/the_kawasaki_concours)

Thousands of pix so get a beverage and get comfy.

Title: Re: Need Helibar c-10 Pic of throttle cable routing
Post by: Pfloydgad on August 29, 2011, 09:03:14 PM

Here you go. Route down the front of the tube, then back and under the top bar mount tree and back to the carbs.
Hope this helps.
Ride safe all.
Greg

Title: Re: Need Helibar c-10 Pic of throttle cable routing
Post by: sroby on August 30, 2011, 04:56:11 AM

Thx Gents for that much needed info.  Regards Steve

Title: Re: Need Helibar c-10 Pic of throttle cable routing
Post by: sroby on September 03, 2011, 07:52:13 AM

Finally had some time this morning and got the T-cables routed correctly no binding ran them down the left side and underneath the back bone throught the triangle head brace and exit to the right side of the steering stem.  Again thx  for the input. Regards Steve