Kawasaki Concours Forum
The C10, aka Kawasaki Concours - The Original => Accessories and Modifications - C10 => Topic started by: mach1charlie on May 27, 2011, 08:57:31 AM
-
What is carb bowl screw size ?
Is fuel line ID 1/4 inch ?
will a piolt jet BS30/96 #37.5 fit my carbs ?
Thanks in advance for your time...
-
Screws to hold the bowl on: 4 mm x 16 mm long with .70 pitch (pitch I'm going off memory as it is not listed)
Fuel Line is: 8 mm or closest American SAE size 5/16"
-
I attempted to give a fellow COG member a replacement carb bowl screw once from the spare set I have. I had to give him the entire carb bowl and screw because the screws/bowls I had were a different size than the screws/bowls he had. I don't know how isolated an incidence this was but just be aware that there may be more than one "correct" size.
-
Murph only has one kit (Stainless Steel Carburetor Screw Kit for Your Concours (http://www.murphskits.com/catalog/product_info.php?cPath=1_95&products_id=78)) listed so I think they are all the same. Maybe you are referring to the drain?
-
The screws that hold the bowls on are all the same size, the DRAIN screws are different. i've seen 3 different types, one for a slot head screwdriver (very early models) one that uses a larger hex,(early 90's) I'm guessing around 4.5 - 5mm,, and the later ones that use the 3mm hex.
On BIG caution I want to throw out there is DON'T OVERTIGHTEN the drain screws? they're tapered and can literally "drive apart" the bowl and destroy it with a big crack! steve