Kawasaki Concours Forum
The C-14, aka Kawasaki Concours-14, the new one :) => Accessories and modifications - C14/GTR 1400 => Topic started by: almightys on September 26, 2012, 06:32:08 AM
-
Needed a quick bit of into and my searching abilities suck and not turning up results i am looking for.
I am in process of installing symatec heated grips. I have a wiring question. I found the two barrel styel connectors under the left panel birds nest. One is solid color and other has a stripe. Is one power and other ground?
I need to wire one of them to switch and will I then tie the ground wires from heated grips to the other connector?
Any help mucho apprecated. electrical aint my thing
Oh I have a 2008 model
-
Check these pics from Fred Harmon.
http://www.pbase.com/fredharmon/accleads (http://www.pbase.com/fredharmon/accleads)
-
Thanks, i was able to locate them. My question is which one is ground and which is power to run up to heated grip switch
-
Normally the "hot" wire will have a protected female connector. Pretty sure this is the case with this connector. I'm replying on the run or I would dig a little more for you.
-
Normally the "hot" wire will have a protected female connector. Pretty sure this is the case with this connector. I'm replying on the run or I would dig a little more for you.
Ah ok, The black one has that shield cover over it