Post 3: Instructions (text + attached photos)
These instructions are for mounting the light bar on the bottom of the license plate. Remove license plate. Drill a small hole, the size of the Admore cable, directly under the license plate light (see photos). When drilling, be careful not to damage the license plate light cable behind the fender. Take off the seat and remove the tool box. Remove the relay attached to the tool box. Pull the ECU up and move it forward out of the way. Remove the two nuts on the base pan that hold the rear fender in place. Thread the Admore cable through the hole you just drilled in the fender. Look under the bike above the tire, you will see the cable for the license plate light going through a square hole. Now that the fender is loose, you can thread the Admore cable through the same hole, do so.
Mount the Admore bracket to the bottom of the license plate (many state plates have two holes on the bottom of the plate already). The bracket should be offset so the Admore can be mounted to the bracket (using the two small screws and nuts on the sides), lower than the holes that hold it to the plate. This will prevent the Admore from blocking the plate. For a more finished look, mounted the bracket behind the plate instead of in front. This install used white nylon plate mounting bolts to attach the Admore to the plate and reflector bolts to attach the plate to the bike (see photos). UPDATE: A better WAY to mount it is listed in post 30
http://www.zggtr.org/index.php?topic=2505.msg197619#msg197619 Wrap the Admore cable around the license plate bracket once, then mount the whole assembly to the bike. This will give you a service loop for later. Take up the slack in the rest of the cable going into the bike and tie wrap it to the license plate light cable under the bike.
Locate the black "boot" near the rear of the bike, under the seat, which contains all the connectors. There is one connector with three wires- red, blue, black. That is the brake light. You will also see two dual connectors with green and black wires. Those are the turn signals. Use the supplied positap connectors as follows and then reassemble everything and you are done:
Bike Function Admore
Red Tail light Red and Blue
Blue Brake Purple
Black Ground Black
Green Right turn Green
Green Left turn Yellow