« Reply #72 on: May 11, 2021, 05:25:30 AM »
I've got Ivan's ECU flash installed and adjusted idle speed to approx. 1200 rpm as he specified in the instruction that came back with the ECU. Now I've noticed that when I start the bike the idle speed starts at just over 1000 rpm. Then after a few seconds it jumps to well over 2000 rpm and stays there for about a couple of minutes or so. After that it finally drops to 1200 rpm. Is this normal or do I need to adjust something?
I think mine does take a second before it goes into higher idle when cold, but not terribly long. Idle adjustment is normally specified and performed while engine is warm. You will probably want to supply the group lots more info in any case:
Year of bike, miles, did it do that before flash when cold, how long have you ridden it, what was ambient temp, when/what were last services, what type/age gas, is throttle action smooth, how many is a few seconds, what does it do when started again warm?
Logged
Shoodaben (was Guhl) Mountain Runner ECU flash, Canyon Cages front/rear, Helibars risers, Phil's wedges, Grip Puppies, Sargent World seat-low & heated & pod, Muzzy lowering links, Soupy's stand, Nautilus air horn, Admore lightbar, Ronnie's highway pegs, front running lights, all LED, helmet locks, RAM Xgrip, Sena SMH10, Throttle Tamer, MRA X-Creen, BearingUp Shifter, PR4-GT, Scorpion EXO-T1200,etc