I am using BMW mechanical arms. These arms are spring loaded, which hold the BMW windshield tight. The windshiled came with mounting covers. I went with BMW arms because they tilt, go up, they are cheap and easy to find...... why reinvent the wheel? It's amazing how much the angle and up happens on the windshield, with such little movement from the arms.
When the BMW adjustable windshield came out, everyone laughed and though it was a gimick, Now most bikes have them.
As far as the BMW windshield goes, it has a nice flip vent in the bottom and a small flip at the top. Its from a R1150 RT.
The only hold up at this point is I cut down my Cee baily windshield(cee baily acts as a mounting base for the BMW arms) and I made small cuts on the lower bottom of the BMW windshield. I'm not sure on how to finish the edges off?
Any ideas on what to use to finish off cut windshield edges?
Im in a stall over the edges.