« previous next »
Pages: « 1 2   Go Down

Author Topic: C10 seat, rear wheel and tire, drive shaft assembly  (Read 5399 times)

Offline datsaxman@hotmail.com

  • Arena
  • Full Member
  • ***
  • Posts: 338
  • Country: 00
Re: C10 seat, rear wheel and tire, drive shaft assembly
« Reply #20 on: November 11, 2015, 09:31:28 PM »
Oh ... and Amontons published this in ... 1699.  Most of the folks I met while I was teaching Physics were pretty sure that friction depended on contact area.  So don't feel too bad if you are also a few hundred years out of date on this. 

dsm
Logged
2008 ZG14X...ZX14 throttle bodies, full AreaP exhaust, heated grips, Corbin, and more...
161.5RWHP on the dyno
Formerly Silverdammit!

Offline datsaxman@hotmail.com

  • Arena
  • Full Member
  • ***
  • Posts: 338
  • Country: 00
Re: C10 seat, rear wheel and tire, drive shaft assembly
« Reply #21 on: November 18, 2015, 07:31:50 PM »
SEAT is spoken for...

DRIVE SHAFT is spoken for...

The leaves only the elephant in the room...the TYRE and WHEEL combo is still available.

$140 shipped to you.  It is a bargain...and 100% ready to go onto your C10!



saxman
Logged
2008 ZG14X...ZX14 throttle bodies, full AreaP exhaust, heated grips, Corbin, and more...
161.5RWHP on the dyno
Formerly Silverdammit!
Pages: « 1 2   Go Up
« previous next »