The windshield is the ceebailey. Its 21.5 with the naca duct vent. I am 5. 7 so I needed the short cut windshield. T-Cro I read up on all the procedures, bought all the aircraft stripper, polishes, rouge aircraft polish u name it I bought it and had it. Stripped out the wheels bearing etc. and started. T cro dont believe the hype it was a pain in the A--. After a Gozilion of my hours and still not looking worth a damn, I through in the towell and called Metro Wheels in Marietta ga. I googled them and they were the no.1 hit. I called them and talked to a guy name Tim, They had recently been bought by a German Engineer name Alex. The rest is history. I was born in Germany So I am kindof partial to German Engineering and finese. Alex did not let me down. His attention to detail is more than mine. I spokle with him and explained what I had done and what I was looking for. They stipped off my uuhhhweee ggoooowwwee mess, polished lightly the lips, shot the center with the German B.B.S. Silver then came back with a slightly more hand polish on the lips( I dont care for the Chrome look) then everything was powdercoated clear with a lifetime warranty on any of there work. The also do repair work I saw wheels in there from Ferrari, Porsche Bmw Ford they had repaired. They had a pic of before a new bmw st front wheel that was wadded up, I held the wheel I could not tell it had been repaired and refinished. These guys are the ****. I did not think about it but maybe an alternative to Kosman on getting wheels enlarged. i cant believe the cost increase from kosman more competiton would surely drive the price down. Anyway the cost was 150.00 per wheel so 300 to me with the way they turnned out was a bargain for me. Anyway thx again for the praise. Regards Steve