OK, I'll admit it. I don't wrench on my bike all that often. I have, just not like some of you guys.
Once in the past, I flushed and bled the front & rear brakes, and clutch system. I had purchased speed bleeders at that time, but it turned out they were the incorrect part numbers so I did things the old-fashioned way. Seemed to work fine.
Time to do this again, and this time I have the speed bleeders offered by Murph's Kits. He sells 7 bleeders and an optional collection system. The bleeders themselves are broken down in two part numbers:
- 2 each SB8125 - these are for the front brake and clutch master cylinders
- 5 each SB8125L - these are for the front brake calipers (2); the rear brake caliper (2); and the clutch slave (1)
I was puzzled because while the front brakes have two calipers, one bleeder for each caliper, I had thought that the rear caliper would have only one.
WRONG. The rear caliper has two bleeders. One is inboard (kinda hidden unless you're looking for it, but visible from the rear) and the other is outboard, plainly seen.
And the clutch slave has only one. So all 7 bleeders are accounted for - I thought for a wild moment there Murph sold me one extra.
Idle question - Fred Harmon, in his video on brake bleeding, does NOT (to the best I can tell) bleed from the inboard bleeder on the rear brakes. He bleeds from the front only, again best I can tell. He goes into significant detail on the front brake bleeding process, but doesn't go into as much detail on the rears.
Does anybody bleed from both bleeders on the rear caliper?