OK, I'm doing a valve adjust, and there it is, a cracked coil casing. about 2" long ways and then some down the side. Still works and is not shorting. Years ago I used a 2 part epoxy on some Wing coils for the same reason, they are still on the bike and working fine. So the $5 question is this, being a Connie, can I do the same with this coil? Your input is required, as its 72 degrees and sunny here in Ohio this morning. Thanks all, and ride safe out there. Greg
I know it is a case to basically keep moisture out, so the epoxy went on, and it sealed it all up, nice and tight. T, I will be doinf your stick coils over the winter break, so get som built. Thanks for the input, RSA, greg
Forgive the bust-in on this thread, but Tony, could you please point me at a source for those aux light brackets? I use the Hella FF50's too, and like your mounting better than mine. Actually, I want to add a couple of their fog beam FF-50's too, so could you advise on a source for a low-mount mounting bracket (brake caliper, maybe?) for those.