So I have a bad TPS on my 08 and two good ones on my 09 which is out of commission. Am I reading this thread correctly that the KDS 3 machine can read the code needed for programming and/or that one of the numbers on the case sticker is the code? Do we have a consensus which of the numbers?
No, the software (KDS) cannot read the numbers; you must type the numbers into the software to have the bike recognize the sensor.
The sensor has the correct number on both the outside as well as the inside of each sensor; should the outside label get dirty or fall off, open the sensor and read the number off the label that is attached to the circuit board itself.
No, no consensus on exactly which number it is. Even worse, no one seems to know (I would take actual knowledge over a consensus anytime.... ). But there are only four numbers in total, so how long could it take to figure out which one is correct?
Brian
I don't always get the answer I want but I always get a chuckle.
I don't always get the answer I want but I always get a chuckle.
Nobody ever gets the answer he / she wants. I went to the eye doctor Wednesday, expecting an new close- vision script [that I had no intention of buying..... again] and was diagnosed with macular degeneration. Hmmmmmm. No treatment, no confirmed, known causes, although smoking is highly suspect. Well, I quit smoking somewhere around 2009 or so and have decided to quit smoking yet again. If the situation does not stabilize, I will quit yet a third time! No holds barred in the fight against blindness!!! Also, had fish and chips tonight, a suspected helpful dietary supplement for th condition.Best of luck with the AMD and the implant grading as well.
All in good humor- I do not expect to go blind. Do not let that act where I put my hands out at 'breast height' to meet new people fool you; I am grading the quality / quantity of the implants I may run into.
ROFLMAO
Brian