Just got my PC from fuel moto and am going to hook it up tomorrow. Came preloaded with the flies out , filter, slip-on map. Do i just plug it in and away I go or do I need to set anything via my laptop?
Just got my PC from fuel moto and am going to hook it up tomorrow. Came preloaded with the flies out , filter, slip-on map. Do i just plug it in and away I go or do I need to set anything via my laptop?
I suggest that you copy the map currently loaded in the pcv to your computer. You may want to experiment with other maps and want to go back to the original map in the future.
It might be usefull to check and/or calibrate the throttle position sensor. "TPS CALIBRATION It is important that the PCV software TPS read 0% when the bike is fully warmed up and at idle. If it needs to be reset make sure the bike is fully warmed up before resetting. With the engine off click on Reset, open throttle to the stop and close, then click OK. "
Reply #4
by
Son of Pappy
on 04 Feb, 2012 23:37
Just a quick reminder, make sure, really sure you have a good, clean ground. And as stated before, make a backup copy well identified as to which MAP it is.