FIXED IT!! A little background I failed to mention before, I replaced the servo unit, because the cable on the old one was frayed. I had an extra servo, because a few years ago when Autozone was clearing them out, I bought every one within a 50 mile radius and sold them at cost to other COG members, but one was missing the wiring harness, so I kept it. Anyway, I started up the bike and had power on the blue wire at the servo. I hadn't done any testing before with the bike running, only with the key in the ON position.
I figured I'd take apart the unit with the frayed cable (I couldn't break it anymore than it already was) and see if I could easily swap any of it out and found that the circuit board and vacuum valve are self-contained in a separate piece from the cable actuator. So, I swapped out the back end of the servo and, voila, I'm cruising again. So, something in the circuit board or vacuum board is messed up.
Thanks everybody for the help and suggestions.