Greetings

I was bored and tired of the over-size muffle on my 09, so I bought a used one from fellow on this form.
I decided to cut 6" off.
I had no problem using a grinder to cut the weld seam off the back of the muffler. I then carefully measured back 6" and cut 6" off the outside of the muffler can.
I then cut 6" off the inside of the muffler baffle that is closed to the muffler intake,
The problem I am having is that the pipe from the header that goes into the muffles is now up against the baffle wall.
Do I need  to cut the baffle plate out or cut the pipe off that in protruding into the muffle from the header?

Thanks
Bryan

I just cut some of the baffle out when I had the same issue.  I cut 9 inches off the can and cut about 11 inches off the baffles.

Thanks
Got if figured out

Yep, remove the baffle is the answer.  Remember, if there aint any pics it didnt happen!!