It has been a while since we have made a batch of these, and it seemed interest was dying down. W/in the last few days I received a query if it would work on a Kawasaki Vaquero, and it looks like they will work on that bike too. So we are going to put a batch together shortly, probably this weekend.
I also have to update the web page as there is really no information there; the page was only put up as an easy way to take orders and keep track of stock. But now people are finding the page on thier own with no previous knowledge of the products, so an update and expansion should be done.
I have noticed that some folks are saying the display eliminator can be installed in a half- hour. Not sure how this happened but quite a few customers have actually unfastened the fuel tank and raised the back of it to install this device. That is absolutely, 100% unnecessary- there is more than enough room behind the tank to catch and pull the wiring up behind the tank and install the device. At most, two of the rubber hoses <may> have to be pulled off to produce sufficient room to install the device. There is a clip on the rear of the fuel tank that the wire harnesses run through so the wires are always visible and provide an easy way to lift them up above the tank. This is how Kawasaki intended the fuel tank be disconnected and left plenty of wire to accomplish this- the same procedure works to install the device without moving the fuel tank at all.
So apologies for not having any product, and we appreciate the patience in waiting for new ones. Again, I hope to have some by Monday and will make them available even if the web page is not updated by that time.