I have tried to install a new set of Vic Ray rear foot peg extensions today. All attempts have been unsuccessful, so far.
Needless to say I, am feeling frustrated. I have attempted to utilize the factory taper shim. That comes with the factory
rear foot pegs. Holding the shim I, have tried the varied ways to put in the Aluminum lowering part. Without the shim, it
fits very loose. There is about a 1/16" gap without the tapering shim. With the tapering shim in place. It is to tight to slip
the lowering part in to place. So here I am, to ask for help from the members. Has any of the forum members, successfully
installed a set of rear foot pegs on a Connie. I'm open to all constructive replies. I thank you in advance.