According to my 08 manual, the Kwak pads are 4 (.16 inches) and 5 mm (.20 inches) thick for the front and the back. Wear limits on both are 1mm or .04 inches.
The wear bars are typically at 1mm.The galfer fronts don't have wear bars that I'm away aware of.
I wish I could see mine. I did a safety check last weekend, and found they were all gone. I sure hope they get here by the weekend...
Jeff
Is that a good idea to rotate them?
I would think that there is an issue with dirty pistons if the pads are not wearing evenly.
might go ahead and rotate them since the outside pads are slightly thicker.
If yer already in there why not just replace them? Pads are pretty cheap...
$120 ain't cheap in my book, I'm just a po country boy.
You should check out the EBC double-H pads, I love em, and you can get em for like $80.