Kawasaki Concours Forum
The C10, aka Kawasaki Concours - The Original => The Bike - C10 => Topic started by: DC Concours on November 04, 2021, 03:04:49 PM
-
Does anyone know if the side stand ever came with a rubber stop? Mine has a hole for something but no rubber stop. The center stand has a stop. I was oiling down there and I don't know how I never noticed it before.
-
If you look at the parts fiche for the muffler, there are two rubber thingies
92075 92075-1002 DAMPER,STAND,CNT 1
92075A 92075-281 DAMPER 1
which seem to plug into the muffler and presumably the center and side stands bump up against them.
No longer have a Concours so can't go out in the garage and check.
-
Thank you. You are always resourceful! That was going to be my next place to look. These are expensive on ebay.
I will have to find something else to go in there. The side stand damper section is 1x1" and the hole where the damper goes is half inch diameter.
The muffler one is 1.75x2" and hole is a little less than half an inch.
Any ideas if there is a small damper I could find at a hardware store to fit either one of these bump sections?
https://www.dropbox.com/s/t344m1aibujaqwu/IMG_1560.HEIC?dl=0
https://www.dropbox.com/s/sgxpmpu75soqnbu/IMG_1563.HEIC?dl=0
https://www.dropbox.com/s/9alk6dw19nc8w8l/IMG_1567.HEIC?dl=0
-
I found a thick rubber grommet in my garage that fit there a few years ago after finding the bump stop was unavailable. Holding up nicely .
-
The rubber stops both fit onto the muffler.
One for the center stand and one for the side stand.
They cost $5 each from a Kawi dealer and they are still available from UK dealers.
The side stand never had anything fitted in the hole.
-
$5 is cheap. I was looking on ebay thinking these would be discontinued, and they were going for $20 there. Thanks for the clarification.
The rubber stops both fit onto the muffler.
One for the center stand and one for the side stand.
They cost $5 each from a Kawi dealer and they are still available from UK dealers.
The side stand never had anything fitted in the hole.
-
I am glad my local dealer has it. But will take 2 weeks. I'll eventually order it from them. But in the meantime I will check around the house. I have grommets laying around I am sure.
Thanks for the idea.
I found a thick rubber grommet in my garage that fit there a few years ago after finding the bump stop was unavailable. Holding up nicely .