need some ideas and moral support.
I was working on getting my turn signals working, had removed the left bar switches/cover. signals were not working and the hazzard button was sticking.
along the way, the horn button broke and could not be repaired, so I ordered a used one off ebay. it arrived Tuesday and I was surprised when I looked to see that the case was not weather or sun faded at all, and the insides had barely a speck of dirt in it. removed the old one and replaced it with the new. Now, not only are my signals still not working, but neither is the headlight. working with the connector plug for that set of wires, it seems that when plugged in, I'm not getting power through to the controls side of the plug. in other words, the harness side of the plug shows voltage, but when plugged in, testing from the back side of the male plug, I'm not getting any reading.
I'm going to swap my controls from the other C10. I know for sure they are working as expected. Hopefully that will indicate that it might be the harness side of the plug.
any other thoughts or ideas of how I should approach this? I've been looking at the schematics and figuring out the wire colors and connections.
did I mention I hate electrical problems?